You can choose from different ESPa nd OLED modules by entering the configuration:
make menuconfigThen go to Component config, OLED and choose your board, if available.
If your board is not available, just select other Board, which will give you the possibility
to select the Pins and the size of the OLED Display manually.
| Num | Description | Size | Norm |
|---|---|---|---|
| 0 | bitocra | 4x7 | ascii |
| 1 | bitocra | 6x11 | iso8859 1 |
| 2 | bitocra | 7x13 | iso8859 1 |
| 3 | glcd | 5x7 | |
| 4 | roboto | 8pt | |
| 5 | roboto | 10pt | |
| 6 | terminus | 6x12 | iso8859 1 |
| 7 | terminus | 8x14 | iso8859 1 |
| 8 | terminus | 10x18 | iso8859 1 |
| 9 | terminus | 11x22 | iso8859 1 |
| 10 | terminus | 12x24 | iso8859 1 |
| 11 | terminus | 14x28 | iso8859 1 |
| 12 | terminus | 16x32 | iso8859 1 |
| 13 | terminus bold | 8x14 | iso8859 1 |
| 14 | terminus bold | 10x18 | iso8859 1 |
| 15 | terminus bold | 11x22 | iso8859 1 |
| 16 | terminus bold | 12x24 | iso8859 1 |
| 17 | terminus bold | 14x28 | iso8859 1 |
| 18 | terminus bold | 16x32 | iso8859 1 |
This is a library of i2c oled ssd1306 for esp-idf. Code modified from ESP-I2C-OLED. I changed the hardware i2c driver into a software one. So you can use any two GPIO pins as SDA and SCL. Remember to call ssd1306_refresh after you draw something new on the screen. External RESET pin function is not implemented yet. Although this lib supports two devices connecting to one i2c bus, I strongly recommend that you connect only one device to one i2c bus at the same time because I haven't tested it. I believe that the gpio pins on esp32 is enough for you to use.