ath10k: provide survey info as accumulated data

It is expected that the returned counters by .get_survey are monotonic
increasing. But the data from ath10k gets reset to zero regularly. Channel
active/busy time are then showing incorrect values (less than previous or
sometimes zero) for the currently active channel during successive survey
dump commands.

example:

  $ iw dev wlan0 survey dump
  Survey data from wlan0
  	frequency:                      5180 MHz [in use]
  	channel active time:            54995 ms
  	channel busy time:              432 ms
  	channel receive time:           0 ms
  	channel transmit time:          59 ms
  ...

  $ iw dev wlan0 survey dump
  Survey data from wlan0
  	frequency:                      5180 MHz [in use]
  	channel active time:            32592 ms
  	channel busy time:              254 ms
  	channel receive time:           0 ms
  	channel transmit time:          0 ms
  ...

The correct way to handle this is to use the non-clearing
WMI_BSS_SURVEY_REQ_TYPE_READ wmi_bss_survey_req_type. The firmware will
then accumulate the survey data and handle wrap arounds.

Tested-on: QCA9984 hw1.0 10.4-3.5.3-00057
Tested-on: QCA988X hw2.0 10.2.4-1.0-00047
Tested-on: QCA9888 hw2.0 10.4-3.9.0.2-00024
Tested-on: QCA4019 hw1.0 10.4-3.6-00140

Fixes: fa7937e ("ath10k: update bss channel survey information")
Signed-off-by: Venkateswara Naralasetty <[email protected]>
Tested-by: Markus Theil <[email protected]>
Tested-by: John Deere <[email protected]>
[[email protected]: adjust commit message]
Signed-off-by: Sven Eckelmann <[email protected]>
Signed-off-by: Kalle Valo <[email protected]>
Link: https://lore.kernel.org/r/[email protected]

Author: Venkateswara Naralasetty

drivers/net/wireless/ath/ath10k/mac.c

@@ -7283,7 +7283,7 @@ ath10k_mac_update_bss_chan_survey(struct ath10k *ar,
 				  struct ieee80211_channel *channel)
 {
 	int ret;
-	enum wmi_bss_survey_req_type type = WMI_BSS_SURVEY_REQ_TYPE_READ_CLEAR;
+	enum wmi_bss_survey_req_type type = WMI_BSS_SURVEY_REQ_TYPE_READ;
 
 	lockdep_assert_held(&ar->conf_mutex);