Bug Report - Rate Limit Exceeded Won't Go Away

[bowyermc]

Bug Report for https://neetcode.io/

I have noticed that occasionally when clicking the "Run" button on any problem, the test cases will execute, but the display of the results will not display in the "Output" tab, rather the contents are completely blank (unfortunately don't have a screenshot of this yet).

Sometimes clicking the "Run" button again will show the contents in the "Output" tab. However, other times I have needed to perform a full page refresh. Even then, sometimes the contents of the "Output" tab will be blank

Out of frustration, I clicked the "Run" button too many times and have received "Rate limit exceeded. Please try again in a moment." error message. I notice this is expected behavior for too many clicks on the "Run" button in a short duration.

However, now I am at a point where I have waited for around 10 minutes before clicking the "Run" button again, and yet it still shows the Rate limit error. I cannot click "Run" on any problem (not just the one I was originally on) without seeing this error. I have also tried logging out of Neetcode.io and logging back in, but still getting the error. It appears that I'm "stuck" and cannot see nominal behavior from clicking the "Run" button

Have I tripped a longer wait time for the Rate limit error? If so, what is that time? And would updating the error message from "Please try again in a moment." to something more precise like "Please try again in x seconds / y minutes" be ideal?

[bowyermc]

Update: This appears to be similar to the following issues:
#4229
#4223
#4221
#4216

[bowyermc]

Update: I'm no longer blocked by the Rate limit exceeded error. However, now I'm seeing the blank content in the "Output" tab again. Here's what I did:

1. Closed out all of my Neetcode.io tabs
2. Opened a new tab and went to Neetcode.io
3. Opened a previous question that saved my code from last session but was failing to run the test cases due to the Rate limit exceeded error
4. Copied my existing code
5. Clicked the "Reset Code" button
6. Pasted the existing code
7. Clicked the "Run" button
8. See blank content in the "Output" tab